220V safety control using relay module - General Electronics - Arduino Forum

Hello. The relay module controls the 220V fluorescent lamp in Arduino. It has been confirmed that the lamp also operates whenever the relay module is switched on and off. But I want to put in a fuse holder because I want to control it while preventing overcurrent more safely, Is it okay to connect the circuit like this?? I'm currently using an Arduino unit3 compatible board. Below is the code used. void setup() { // put your setup code here, to run once: pinMode(9, OUTPUT); } void

Remote light switch - relay and wall switch - Project Guidance - Arduino Forum

Safety check of 230V relay project - General Electronics - Arduino Forum

Powering wemos D1 Mini pro and relay 5V - Microcontrollers - Arduino Forum

Controlling AC Light Using Arduino With Relay Module : 7 Steps - Instructables

Controlling AC Devices with Arduino - SAFELY

help to connect arduino to a desk lamp with relay module - Home Automation - Arduino Forum

Buy Relay module 4 channels with optoisolation - Botland - Robotic Shop

relay switch for 220V - Project Guidance - Arduino Forum

Controlling multiple outlets with SSR Relay module and Arduino - Project Guidance - Arduino Forum