220V safety control using relay module - General Electronics

Hello. The relay module controls the 220V fluorescent lamp in Arduino. It has been confirmed that the lamp also operates whenever the relay module is switched on and off. But I want to put in a fuse holder because I want to control it while preventing overcurrent more safely, Is it okay to connect the circuit like this?? I'm currently using an Arduino unit3 compatible board. Below is the code used. void setup() { // put your setup code here, to run once: pinMode(9, OUTPUT); } void

Relay SPDT Sealed - COM-00100 - SparkFun Electronics

The Basics of Control Relays, Relay Control Systems

In-Depth: Interface One Channel Relay Module with Arduino

DPST 1NO 1NC 8Amp Power Relay Module, AC 220V 230V 240V Control Voltage

Time Delay Relay Circuit

Guide for Relay Module with Arduino

12 Volt DC Solid State Relay using BUZ71A

25A Solid State Relay SSR DC-DC Input 3-32V DC Load 5-220V ​DC DD220D25

ESP32 Relay Module - Control AC Appliances (Web Server)

Product Use: Press the trigger button, the relay pull in and lock, press again, the relay is disconnected, you can also external trigger switch and

1-Channel Self-Locking Relay Module One Button Start-Stop Bistable 10A Load for SCM Control, Household Appliances Control, Industrial Equipment

433Mhz RF ON-OFF DC8-86V 30A Relay Wireless Remote Control Switch - DAIER

Ac100v-220v Adjustable Timer Control Relay Module Turn Off Delay Switch Board For Exhaust Fan Delayed Fan Shutdown Relay Module - Integrated Circuits - AliExpress