relay - How to command a 220v device through a 12v output - Electrical Engineering Stack Exchange

I have a vending control board whose output is 12v-DC but the problem is that with this device I have to control a device whose input is 220V-AC. Can anybody help me make this possible? Sorry for m

Can I control 220v contactor using 12 v relay module. I need to control 220v 1hp water pump and air compressor and a1.5 Hp conveyor motor for my automated system school project

switches - How to connect two power sources to a switch? - Electrical Engineering Stack Exchange

Battery Charger Cut off - Electrical Engineering Stack Exchange

HOW TO INSTALL A RELAY SYSTEM WITH 220 VOLT POWER

optoelectronics - How to connect 111ager Solid State Relay with Arduino to control a 5VDC@2.1A load - Electrical Engineering Stack Exchange

voltage - How to connect two circuits into on light bulb with a switch in each - Electrical Engineering Stack Exchange

Arduino SSR 5V DC (Mager GJ-3FA-L) - Electrical Engineering Stack Exchange

VPI Operation, Installation, and Maintenance - Alstom

power - Switching 240V A/C source between two loads with relays - Electrical Engineering Stack Exchange