Arduino AutoShutdown Using 5V DC Relay or MOSFET - Project

I'm learning how to use relays. I understand their basic function and have managed to build a few projects. But I came across an example that uses a relay or MOSFET to Auto Shutdown Arduino and I'm not sure if I've understood the circuit correctly. When I built this project, the Arduino powers off as soon as I release the button! THIS IS HOW I SEE IT: The relay (which is using NO) is initially LOW, meaning COM and NO are not connected and therefore the Vcc into Arduino's 5V pin is not going to

3V 5V Low Control High Voltage 12V 24V 36V E-switch Mosfet Module For Arduino

Why does my electric circuit to control a 12V circuit (solenoid) with a 5V circuit (GPIO, Arduino) using an optocopler and a Mosfet not work? - Quora

Arduino DC Motor Speed and Direction Control using Relays and MOSFET

Isolated High Power DC Solid-State Relay Shield for Arduino

mosfet - Power off arduino via software - Electrical Engineering Stack Exchange

How to control 12V devices with Arduino. Using Relay vs Using N-Channel MOSFET transistor

Why does my electric circuit to control a 12V circuit (solenoid) with a 5V circuit (GPIO, Arduino) using an optocopler and a Mosfet not work? - Quora

DC Motor Controller using Relay and MOSFET - Arduino Interface

Home Automation - How to Add Relays to Arduino : 10 Steps - Instructables

DIY: Relay Switch Motor Controller - Arduino : 4 Steps (with Pictures) - Instructables

Arduino power shutdown when relay connected - Project Guidance - Arduino Forum

Package Included: 1 x 3V 5V Low Control High Voltage 12V 24V 36V E-switch Mosfet Module For Arduino

3V 5V Low Control High Voltage 12V 24V 36V E-switch Mosfet Module For Arduino

123 Arduino Auto Shutdown (and switch off)